Cleaning fluid for print heads - yellow, inside 100 ml

  • Cleaning fluid for print heads - yellow, inside 100 ml

Brand: OCP

Capacity: 100 ml

Stock code: 0800B00O10000100

  • Attention! Fields marked with an asterisk (*) are required

    * I have read and accept the Terms and Privacy Policy.

    * I agree to receive the newsletter and information about promotions.

Delivery cost

Delivery cost depends on the destination and it is individually calculated. You will be informed about this cost in order confirmation. If you need this information earlier, contact our Sales Department please

2,03 € gross

/ 1,65 € net

Recommend Us
To recommend a product, you must be logged in

Please inform me about price decrease of this product.

  • * I have read and accept the Terms and Privacy Policy.

    * I agree to receive the newsletter and information about promotions.

Operating manual:
Replaceable print heads (Hewlett Packard, some series of Lexmark, Canon series 2000/ 4000/ 5000).
Small dirt:
pour the liquid on paper towel and leave the cartridge on for about 15-30 minutes in position such how it is in printer, after this time clear up the nozzles area.
Large dirt:
fill up the flat pot with Rinse Solution and leave the cartridge for even 12 hours in position such how it is in printer
ATTENTION: Do not dip cartridge in Rinse Solution higher than nozzles level. Otherwise you can damage (delaminate) the plastic parts of cartridge.

You can use Rinse Solution in inside of cartridge. There is a higher efficiency of the cleaning process if Rinse Solution is heated up to approx. 55°C. It is very important to not cross this border. Because electronic plates are sticked, so too high temperature causes unsticking of them as well as damage of cartridge electronic. If you apply the liquid inside you have to suck off it with syringe with suction device after 10 minutes.

ATTENTION: There is a higher efficiency of the cleaning process if Rinse Solution is heated up to approx. 55°C. But it is very important to not cross this border.

Course of action in case built-in heads (Epson models)

Proceed with following recommendations:
  • start printing,
  • during printing remove the plug from power socket (the best if head stops in the center)
  • cut off the cloth to print head size,
  • pour the liquid on cloth,
  • place the cloth in the channel that the print head possess over (usually on the right hand side of the printer),
  • move the print head to this place,
  • wait about 30 minutes,
  • remove cloth,
  • switch on the printer.