Glass clock for sublimation and engraving
- The watch for printing is made of glass; a round white dial with numbers is surrounded by a mirror frame with
- Square clock with a white circle for printing is covered with a polyester layer - the presence of polyester particles allows for marking the round circle using the sublimation technique
- The print area has a diameter of 150 mm
- The clock for personalization is suitable as a base for both sublimation and laser engraving
- Clock for sublimation is made from glass, your print will be permanent, impalpable and esthetic
- It has three, black hands of clock (minutes, hours and seconds)
- Battery clock mechanism outside (battery is not in the set)
- You can transfer your print on the clock in a flat press after removing clock mechanism (what is very easy)
- A diy sublimation clock blank is ideal for personalised gifts or a promotional product adding clock face digits and your artwork
- See other clocks
- prepare the print (print on right side - without mirror effect)
- for sublimation use a silicone mat, which should be put on the bottom plate
- place printed paper on the mat, e.g. TexPrint (print - side up)
- on the prepared paper, place the item you want to sublimate (the white surface for sublimation should be in front of the print)
- heat the print at 180oC for 7-10 minutes with medium pressure
See an overview video below: