Sign up for our Newsletter:
Receive information about new products and promotions !

I have read and accept the Terms and Privacy Policy.

I agree to receive marketing information (Newsletter) to my mailbox. I can unsubscribe from the Newsletter at any time here

Our sites (ticks and movies)

Flex and flock films remover- spray

Capacity: 400 ml

Stock code: 6U50001R4

Your ID:
Name and Surname:
Post code:*
Your e-mail:*
Phone number:
Question:*
Attention! Fields marked with an asterisk (*) are required

* I have read and accept the Terms and Privacy Policy.

I agree to receive marketing information (Newsletter) to my mailbox. I can unsubscribe from the Newsletter at any time here

DELIVERY COST

Delivery cost depends on the destination and it is individually calculated. You will be informed about this cost in order confirmation.

If you need this information earlier, contact our Sales Department please.

46,95 € gross

/ 38,17 € net

To recommend a product, you must be logged in

Please inform me about price decrease of this product.

Yours e-mail address:
* I have read and accept the Terms and Privacy Policy.

* I agree to receive marketing information (Newsletter) to my mailbox. I can unsubscribe from the Newsletter at any time here

PUR-O-CLEAN fluid for removing (removing) flex and flock films in aerosol - the new form of the product makes its use much easier
Capacity: 400ml
The spray preparation is used to remove incorrectly made prints from flex and flock thermal transfer foils
The film remover can be used on both white and colored fabrics
Flock and flex film remover acts as a solvent - removes glue from the film without causing damage to clothing

Instructions for use:

Spray the preparation on the incorrectly heated film from the inside of the printed clothing (on the foil from the bottom of the fabric)
Wait a few seconds and gently remove the film from the fabric
Wash your hands thoroughly after removing the foil
It is recommended to gently wash the fabric after removing the foil. With some films, removal (peeling) leaves traces of glue or discoloration on the material

Precautions:

Please read the instructions carefully before using transfer film remover
Flex remover is harmful if ingested, in contact with skin or inhaled
Print remover should be used in ventilated areas, always wearing protective gloves
In case of skin contact, wash the affected area immediately with plenty of water
In case of eye contact, flush eyes with running water for 15 minutes
If swallowed, contact a physician immediately

Watch how works Flex removing liquid in our video: